01-28-2019, 11:56 AM | #23 | ||
First Lieutenant
101
Rep 353
Posts |
Quote:
|
||
Appreciate
0
|
01-28-2019, 12:03 PM | #24 | |
Major General
2736
Rep 6,734
Posts
Drives: 'E46 M3 Race Car, '23 X7
Join Date: Jan 2009
Location: Wisconsin - Instagram - @slicer_m
|
Quote:
Take a closer look at my side profile picture. Note that the front fender has a taller arc than the rear. Look at the relationship between the rocker panel and the ground. See how there is more front fender to wheel gap but the rocker panel is angled downward towards the front? There is an appearance of 'reverse rake' but it's simply a larger fender gap in the front due to the wheel arc design difference between front and rear - as it is on all F-series cars. Note that H&R springs that I have lower the front by 1.75" and the rear by 1.4". I measured the distance between the bottom of the rocker panel to the ground. Front is 5" and rear is 6".
__________________
'23 X7
'04 M3 - Fall Line Motorsports Built Race Car - S65 swap, Dry Sump, Bosch Stand-Alone ECU, Drenth Sequential Trans, MCS 3-Way, Flossmann Wide Body, Brembo Motorsports Brakes, Drexler LSD, BBS E88 Etc. INSTAGRAM - @Slicer_M Last edited by slicer; 01-28-2019 at 12:13 PM.. |
|
Appreciate
0
|
01-28-2019, 12:06 PM | #25 |
First Lieutenant
101
Rep 353
Posts |
Ah gotcha.. didn't realize that all F31s are xdrive. Anyways, thanks for sharing your specs and knowledge!
|
Appreciate
0
|
01-28-2019, 12:15 PM | #26 |
Major General
2736
Rep 6,734
Posts
Drives: 'E46 M3 Race Car, '23 X7
Join Date: Jan 2009
Location: Wisconsin - Instagram - @slicer_m
|
You are welcome - I hope it's helpful!
__________________
'23 X7
'04 M3 - Fall Line Motorsports Built Race Car - S65 swap, Dry Sump, Bosch Stand-Alone ECU, Drenth Sequential Trans, MCS 3-Way, Flossmann Wide Body, Brembo Motorsports Brakes, Drexler LSD, BBS E88 Etc. INSTAGRAM - @Slicer_M |
Appreciate
0
|
01-28-2019, 04:25 PM | #28 | |
KendrickOak
359
Rep 201
Posts |
Quote:
Anything is possible if you put your mind to it lol |
|
01-28-2019, 04:29 PM | #29 | ||
First Lieutenant
101
Rep 353
Posts |
Quote:
As for myself, I don't want to deal with camber or go the bag route yet. Trying to see what's the most flush but still aggressive while on simple springs or coil overs (under $1000) |
||
Appreciate
0
|
01-28-2019, 08:46 PM | #30 | ||||||
KendrickOak
359
Rep 201
Posts |
Quote:
Quote:
I would just save the 1k till it's 4K and get bags. Best investment in my opinion |
||||||
Appreciate
0
|
02-09-2020, 01:44 PM | #31 |
Registered
2
Rep 4
Posts |
And so it was! I went with this setup for my F32 and it turned out great! Sorry to revive this old thread but I had an additional question. I’m trying to go lower now and thinking about going with the H&R SS. Would shorter bump stops be enough with this setup? I have the 704 M sport suspension.
|
Appreciate
0
|
08-10-2020, 03:54 AM | #32 | |
the senate
15
Rep 25
Posts
Drives: 2016 435i
Join Date: Jun 2020
Location: Washington
|
Quote:
19 x 9.5 et35 square with 255/35/19 |
|
Appreciate
0
|
09-30-2020, 02:22 PM | #33 |
New Member
0
Rep 7
Posts |
|
Appreciate
0
|
09-30-2020, 05:24 PM | #34 |
Major General
2736
Rep 6,734
Posts
Drives: 'E46 M3 Race Car, '23 X7
Join Date: Jan 2009
Location: Wisconsin - Instagram - @slicer_m
|
Sports. SS doesn't exist for f31
__________________
'23 X7
'04 M3 - Fall Line Motorsports Built Race Car - S65 swap, Dry Sump, Bosch Stand-Alone ECU, Drenth Sequential Trans, MCS 3-Way, Flossmann Wide Body, Brembo Motorsports Brakes, Drexler LSD, BBS E88 Etc. INSTAGRAM - @Slicer_M |
Appreciate
0
|
10-01-2020, 06:11 AM | #35 |
New Member
0
Rep 7
Posts |
|
Appreciate
0
|
10-01-2020, 07:27 AM | #36 |
Major General
2736
Rep 6,734
Posts
Drives: 'E46 M3 Race Car, '23 X7
Join Date: Jan 2009
Location: Wisconsin - Instagram - @slicer_m
|
No, it wouldn't be too low. Worst case you would need camber plates.
__________________
'23 X7
'04 M3 - Fall Line Motorsports Built Race Car - S65 swap, Dry Sump, Bosch Stand-Alone ECU, Drenth Sequential Trans, MCS 3-Way, Flossmann Wide Body, Brembo Motorsports Brakes, Drexler LSD, BBS E88 Etc. INSTAGRAM - @Slicer_M |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|