10-16-2018, 04:03 AM | #1 |
New Member
16
Rep 29
Posts |
backup camera installation NBT
Hi all,
after my NBT retrofit for my f30 i want to install a backup camera i've purchased a kit like the picure attached i already have the quadlock connected do you know how i can connect it on the back of the NBT quadlock? thank you |
10-16-2018, 10:44 AM | #2 |
New Member
4
Rep 20
Posts |
I'm planning on doing this as well. I'm assuming you're using an emulator for your NBT?
I haven't done my research yet, and definitely haven't tried it out, so guys please correct me if I'm wrong. But would you be able to connect this piece between the NBT and the emulator? So something like: Car -> Emulator -> Camera Interface -> NBT If this doesn't work, my plan would be to just splice the wires directly into my emulator. I think it's like 4 or 6 lines that needed to be spliced in? |
Appreciate
0
|
10-18-2018, 03:07 AM | #3 |
New Member
16
Rep 29
Posts |
i have the emulato only for the touch controller not for the canbus the user says that it's plug and play so i have to connect it after the quadlock
but i don't like to have 3 quadlock in the back of the nbt so i would like to save 1 quadlock connecting directly to the previus one that's why i'm asking how to do it i've made 1 diagram and asked the supplier will keep you posted thank you |
Appreciate
0
|
10-22-2018, 04:39 AM | #4 |
New Member
16
Rep 29
Posts |
Hi guys, i've installed and coded the backup camera all the wirings are done correctly but when i put the camera in reverse i got the following
do you know what can the problem be? i run the wire on the right side next to the 12v battery cable it might be that that is making distorsion? i don't think so for me is the backup camera module thank you |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|