F30POST
F30POST
2012-2015 BMW 3-Series and 4-Series Forum
BMW Garage BMW Meets Register Search Today's Posts Mark Forums Read
BMW 3-Series and 4-Series Forum (F30 / F32) | F30POST > Technical Forums > Tracking / Racing / Autocrossing > Autocross specific tire pressure advice for run flats?
European Auto Source (EAS)
Post Reply
 
Thread Tools Search this Thread
      10-05-2019, 05:04 PM   #1
Desertnate
Private First Class
United_States
54
Rep
154
Posts

Drives: BMW 435i
Join Date: Jul 2019
Location: Swansea, IL

iTrader: (0)

Garage List
2016 BMW 435i  [0.00]
Autocross specific tire pressure advice for run flats?

This isn't a question regarding proper tire pressure for street use. I can get that off the door jam sticker.

I've run a few autocross events now and I'm still trying to get a handle on proper tire pressures. While I'm sure I'm still carrying too much speed into the corners, I still feel like something isn't right at the front of the car and I'm not getting the grip I thought I would on turn in and experiencing almost more oversteer than my GTI which was FWD. Some might be my fault and some might be the horrible 19" Bridgestone S001 runflat tires too I'm sure.

At the SCCA novice school, one of the instructors who is also an EVO School instructor suggested running the tires at max PSI up front and max -5 in the rear in heavier cars like my BMW to keep the tires from rolling onto the sidewall in the turns and help keep the handling neutral.

So far, I've done two events using the instructors guidance and I didn't come even close to the sidewall wear. On my next event, I left the rears the same but dialed back 2 PSI in the front. I didn't really notice any handling difference, but did notice I was using the entire tire tread, but was just shy of the sidewall.

After hunting around I found a chart on tire rack that mentions running 35~40 front/30~40 rear. Since the door jam sticker on my car states 35/38 for my 19" wheels, this recommendation isn't much different from street use.

Yes, I know RFT's are part of the problem and I'll solve that issue when they wear out. At this time, I'm not heavily enough into the sport to invest in a dedicated set of wheels and tires. I'm dong this for my own improvement and entertainment.

Any advice on set up for the tires which will give me a good platform while I work on improving my skills?
Appreciate 0
      10-09-2019, 09:56 PM   #2
jmg
Major General
jmg's Avatar
United_States
7410
Rep
8,737
Posts

Drives: F80 M3 CS, I01 i3 REx LCI
Join Date: Mar 2013
Location: Orange County, CA

iTrader: (0)

Garage List
Quote:
Originally Posted by Desertnate View Post
This isn't a question regarding proper tire pressure for street use. I can get that off the door jam sticker.

I've run a few autocross events now and I'm still trying to get a handle on proper tire pressures. While I'm sure I'm still carrying too much speed into the corners, I still feel like something isn't right at the front of the car and I'm not getting the grip I thought I would on turn in and experiencing almost more oversteer than my GTI which was FWD. Some might be my fault and some might be the horrible 19" Bridgestone S001 runflat tires too I'm sure.

At the SCCA novice school, one of the instructors who is also an EVO School instructor suggested running the tires at max PSI up front and max -5 in the rear in heavier cars like my BMW to keep the tires from rolling onto the sidewall in the turns and help keep the handling neutral.

So far, I've done two events using the instructors guidance and I didn't come even close to the sidewall wear. On my next event, I left the rears the same but dialed back 2 PSI in the front. I didn't really notice any handling difference, but did notice I was using the entire tire tread, but was just shy of the sidewall.

After hunting around I found a chart on tire rack that mentions running 35~40 front/30~40 rear. Since the door jam sticker on my car states 35/38 for my 19" wheels, this recommendation isn't much different from street use.

Yes, I know RFT's are part of the problem and I'll solve that issue when they wear out. At this time, I'm not heavily enough into the sport to invest in a dedicated set of wheels and tires. I'm dong this for my own improvement and entertainment.

Any advice on set up for the tires which will give me a good platform while I work on improving my skills?
I'm only an intermediate but here's my take:

If you are encountering oversteer than lowering the rear pressure and increasing the front is correct. However, there is only so much tire pressure can correct for. Perhaps you are simply going too fast for the tires or you are on the throttle too soon. Personally, I find oversteer to be preferable in a tighter technical autocross. What I'm constantly fighting for is grip on throttle for corner exit which can be helped by a later apex, better rubber, and better throttle modulation.
__________________
2018 F80 ///M3 CS - Lime Rock Grey Metallic
2019 I01 i3 BEV - Giga World
Previous: F80 M3 | I01 i3 Rex LCI | I01 i3 REx | F30 340i M Sport ZTR | F30 328i Sport | Audi B7 S4 25Quattro #33 of 250 | E21 320i
Appreciate 0
      10-10-2019, 02:15 PM   #3
Desertnate
Private First Class
United_States
54
Rep
154
Posts

Drives: BMW 435i
Join Date: Jul 2019
Location: Swansea, IL

iTrader: (0)

Garage List
2016 BMW 435i  [0.00]
You're M3 is going to be a different animal than my 435, but do you increase with air pressure at all to prevent sidewall wear issues, or do you run the normal street setings and then adjust as they heat up?

I'll continue to keep the fronts a little higher to balance things out. At this point I'm just wondering what a good starting point might be.
Appreciate 0
      12-02-2019, 12:20 PM   #4
swomerva
Registered
2
Rep
4
Posts

Drives: 435i Gran Coupe
Join Date: Apr 2019
Location: VA

iTrader: (0)

I overheated about 1/2 inch up the sidewalls on my RFTs in two autocrosses at around 30-32 PSI all around. I should have increased the tire pressures before I went out but I was in a rush just to get the numbers on both times. I'd definitely make sure you don't go too low as they'll roll over, I'd probably stay >35lbs. Admittedly I am not the smoothest driver as I was having way too much fun sliding around so I am at least partially to blame.
Appreciate 0
      12-04-2019, 03:01 PM   #5
romemedrano
Enlisted Member
9
Rep
31
Posts

Drives: BMW F30
Join Date: Oct 2019
Location: Bay Area

iTrader: (0)

Ive been road course tracking my f30 on run flats. I usually like them around 30 psi hot but autoX is different world.
Appreciate 0
      12-06-2019, 02:34 AM   #6
RMachuca3d
Lieutenant
RMachuca3d's Avatar
251
Rep
490
Posts

Drives: F30 328i Msport
Join Date: Aug 2018
Location: WA

iTrader: (2)

Garage List
Camber, you need more of it , try the M3 LCA, it'll give you a bit of camber up front which might make a big difference while solid state cornering and keeping the front end in line better during max gload. You might give up a smidge of turn in immediacy, but that's more than compensated for mid corner.
Appreciate 0
Post Reply

Bookmarks

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -5. The time now is 01:38 AM.




f30post
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
1Addicts.com, BIMMERPOST.com, E90Post.com, F30Post.com, M3Post.com, ZPost.com, 5Post.com, 6Post.com, 7Post.com, XBimmers.com logo and trademark are properties of BIMMERPOST