10-23-2017, 03:39 PM | #1 |
Private
18
Rep 62
Posts |
JB1 vs JB4 Vs Dinan Stage 1/2 435i with PPK
Hi,
I'm looking to see what further I can do with a chip in my 435i with Mpower ppk to get better low end pull. Looking at JB1 vs Jb4 vs dinan stage1 or 2. Lets pretend money is not the primary factor. I'm not likely to further mod the car beyond this chip, and I have the extended warranty after the existing warranty so I've accepted that I'll have to be yanking whatever I put in out if I am taking the car in for service. Thanks! |
10-23-2017, 03:56 PM | #2 |
BimmerPost Supporting Vendor
4908
Rep 115,980
Posts |
If you are not going to mod further either JB+ or JB Stage1 will probably be the best options..
If there is a possibility of further modding then JB4 would be the way to go as its a much complete tune then any of the above. Mike |
Appreciate
0
|
10-23-2017, 05:49 PM | #3 |
Private
18
Rep 62
Posts |
Thanks. And either of those can be used in addition to the existing ppk?
|
Appreciate
0
|
10-23-2017, 06:56 PM | #4 |
Captain
364
Rep 775
Posts |
Dinan Stage 2 pulls hard in low rpm and had it for a few months on the 435i here. Your warranty will be fine and, frankly, once warranty is gone then consider bm3. JB-whatever is good, yet bm3 is really the way to go imho.
__________________
Enjoy the Drive,
Steven 2014 435i M-Opt, M LSD, Dinan CAI/IC/BTurbo/Stage 4, ER TIC/CP, GFB DV+, Fabspeed HJS cat DP & Mich PS4S. |
Appreciate
1
FSociety3812.50 |
10-24-2017, 11:50 AM | #6 | |
Private
27
Rep 70
Posts |
Quote:
__________________
F30 335. Dinan Stage 4 including suspension. Wavetrac LSD.
|
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|