DSC+Steering Angle Sensor issue

zen0s · 08-09-2018, 01:18 AM

hey guys,

I recently switched out paddle shifters and while taking the steering wheel out, i accidentally moved clockspring. Since then I'm getting DSC and Angel Sensor fault codes.

I did recalibrate the sensor by turning the steering wheel all the way to left and right. Fault code did go away but whenever I disconnect the battery it comes back, which never happened before.

I'm just curious if this is something I should worry about? How do I center/neutral clockspring again? Do I need to go to dealer to recalibrate it properly?

Attached is the screenshot of fault codes on ISTAD

Thank you

j09333 · 10-01-2018, 07:11 PM

Is there a way to switch off angle sensor?
Since I added more angle to front, I am constantly getting error when doing full angle drift which only goes away by restarting the vehicle.

08-09-2018, 01:18 AM	#1
zen0s Private 38 Rep 94 Posts Drives: 2018 M3 Competition Join Date: May 2014 Location: Maryland iTrader: (0)	DSC+Steering Angle Sensor issue hey guys, I recently switched out paddle shifters and while taking the steering wheel out, i accidentally moved clockspring. Since then I'm getting DSC and Angel Sensor fault codes. I did recalibrate the sensor by turning the steering wheel all the way to left and right. Fault code did go away but whenever I disconnect the battery it comes back, which never happened before. I'm just curious if this is something I should worry about? How do I center/neutral clockspring again? Do I need to go to dealer to recalibrate it properly? Attached is the screenshot of fault codes on ISTAD Thank you Attached Images
	Appreciate 0 Tweet Quote

10-01-2018, 07:11 PM	#2
j09333 Private 58 Rep 57 Posts Drives: F80 M3 Join Date: May 2015 Location: 대한민국 iTrader: (0)	Is there a way to switch off angle sensor? Since I added more angle to front, I am constantly getting error when doing full angle drift which only goes away by restarting the vehicle.
	Appreciate 0 Quote