[pici192]

Originally Posted by atzebmw

Possible part numbers for your car:

61359374506
61356809049
61356819332
61356819333
61359362398
61359362394
61359298959
61359866978
61359866982
61359329704
61359499001

Thanks for help!
Based on earlier reply, to check the part number on site:
https://www.realoem.com/bmw/enUS/sho...diagId=61_2802
Control unit, rear electronic module
No. Description Supp. Qty From Up To Part Number Price Notes
01 Control unit, rear electronic module 1 61359374506 ENDED
01 Control unit, rear electronic module 1 61356809049 ENDED
01 Control unit, rear electronic module 1 61356819332 ENDED
01 Control unit, rear electronic module 1 61359866978
01 Control unit, rear electronic module 1 61359499001

I did research based on pin numbers/positions, and looks the list of REMs are fitting with my F31 above.

I have possibility to buy 61359866978, will see how will goes....

[massimorifo]

Hello everybody
recently a friend flashed the eprom in in the fem of an f31 to remove anti-tuning and remove the fap.
now the car recognizes the key only if it approaches the steering wheel and not always.
the car does not start anymore.
with esys i can't find f30.
could someone help me?
thank you

[Siki78]

Originally Posted by massimorifo

Hello everybody
recently a friend flashed the eprom in in the fem of an f31 to remove anti-tuning and remove the fap.
now the car recognizes the key only if it approaches the steering wheel and not always.
the car does not start anymore.
with esys i can't find f30.
could someone help me?
thank you

FEM or DME?
Probably transport mode activate. Try with esys and transmiter

[ogmilokush]

Originally Posted by Claudio

Hi guys,

I have to replace REM due a reverse light malfunction not cadable on my F31, so I bought a used REM with different PN, here below the differences

Installed:

PN 61.35-9392700-01
HWAP 000000F4C
HWEL 003.000.002
BTLD 003.029.030
SWFL 003.029.030



Used

PN 61.35-9392702-01
HWAP 000000F4B
HWEL 003.000.002
BTLD 003.029.030
SWFL 003.029.030

After install it i get 5 error in REM , one of this is 0080482E wrong hardware version.

I save a backup configuration from old REM and then write it on the used Rem with BMAicoder but no result.

Is it possible to change or coding HW configuration?

If it's so, what i need to do?

Thanks!!!!!

Did you ever fix the issue, I’m on the same boat and waiting for cables to code a new unit. Do you think re flashing the unit might fix the issue?