05-30-2021, 08:50 PM | #2 |
2012 BMW M135i F20
5
Rep 11
Posts |
I've disconnected partway through and forced stoppage of ISTA+ and hadn't gotten that problem before. I was only diagnosing though. Just rebooted everything and reconnected..
Check your OBD port for bent contacts as well.. i had that issue on my car. Were you programming when it crashed? |
Appreciate
0
|
06-05-2021, 08:31 PM | #3 | |
Major
53
Rep 278
Posts |
Quote:
|
|
Appreciate
0
|
06-08-2021, 01:13 PM | #4 |
2012 BMW M135i F20
5
Rep 11
Posts |
Check your obd socket on the car and see if any connections are bent. I had a bit of a problem and had to get tweezers to been them back so they'd make contact. Are you using an enet cable?
|
Appreciate
0
|
06-11-2021, 08:37 AM | #5 |
Major
53
Rep 278
Posts |
The pins are good when I plug my enet cable in ista reads my vin so I be that its a problem with the enet ip address and I don't know how to configure that it dosent obtain on its own
|
Appreciate
0
|
06-15-2021, 02:48 AM | #7 |
Enlisted Member
7
Rep 35
Posts |
hi
it happened to me similar once, I did following in a CMD : netsh winsock reset netsh int ip reset ipconfig /release ipconfig /renew reboot and then hoping it'll work edit : sometimes the car just need to be locked for 15min (obd not connected) and then retry from start |
Appreciate
0
|
Post Reply |
Bookmarks |
Thread Tools | Search this Thread |
|
|