10-24-2017, 07:11 AM | #1 |
New Member
5
Rep 7
Posts |
Coding 5AG retrofit
Hi guys i tried to code 5AG but i have problem with CAF files:
So after installation i updated the VO, i coded all modules and than i tried to initialize flex-ray... but every time the initialization was successful when i should get error since the HC2 module wasn't coded yet. So if the flexray initialization was successful i wasn't able to see HC2 (or SWW in ISTA+). So i opened port 4 flex ray with tool32 and since then i was able to see HC2 BUT!!! : In this step i should create a Cafd file for HC2. I have two HC2 modules one new and one used. My i-step is F020-15-07-502 On the used HC2 e-sys shows me files form y2012 and on the new one i get from: F20-16-03-500 till F20-17-03-505 So non is compatible with the car i inserted F20-16-03-500 but in ISTA+ i get : Ofc coding in ISTA does nothing and if i reinitialize flexray with ISAT+ it closes port 4 and SWW disappears. Can some one help me with some advice ? |
04-07-2018, 04:03 PM | #3 |
Second Lieutenant
35
Rep 277
Posts |
I have the same problem did complete retrofit, initalised flex ray didn't get error but succes and no HC2 module to find. So cant installed CAFD file
Don't have tool32 so can't open flexray. Anybody any ideas what the problem is? |
Appreciate
0
|
12-15-2018, 08:09 PM | #4 |
Registered
0
Rep 4
Posts |
hi,i have same problem with you
I have the same problem with you, do you hc2 module found, thx
|
Appreciate
0
|
12-16-2018, 07:04 PM | #6 |
Registered
0
Rep 4
Posts |
I already open the port by tool32, hc2 module was found and sww working now
but had an error code in Rheingold, that remind initialization FlexRay. but the FlexRay port will be closed when I initialization FlexRay. what can I do next? Thx |
Appreciate
0
|
03-19-2021, 08:33 AM | #7 |
New Member
2
Rep 12
Posts |
HI , i have the same problem . Did you solved it ?thanks .
|
Appreciate
0
|
09-12-2021, 12:16 AM | #9 |
New Member
0
Rep 5
Posts |
|
Appreciate
0
|
09-12-2021, 02:24 PM | #10 |
Lieutenant
136
Rep 525
Posts |
reset flexray after opening port
steuern_flexray_pfad=>0x03;0x01=>F5 steuern_reset_learn_flexray=>F5
__________________
Successfully retrofit on BMW F30 335xi 248,302,3AG,430,5AG,5AS,6NS,8TH and IHKA3
Last edited by Siki78; 09-12-2021 at 02:34 PM.. |
Appreciate
1
yuwhehe3.50 |
Post Reply |
Bookmarks |
|
|