[Moffo]

Hey guys, I have a 2017 BMW F32 and I was wondering what potential offsets can I run for deep dish wheels? My car is going to be on Silver's Neomax Coils with about a 2-2.5 inch drop.

Wheels I'm considering:
BBS Super RS
BC Forged MLE81

I'm planning on running 19x9.5/19x10 or 19x9.5/19x10.5 (Not sure if the 10.5 would fit). Any guidance or additional info would be greatly appreciated. If I'm missing any info u guys may need, please let me know!

Thanks again!

[blumagic]

lowest offset in front is going to be around +20 with ~2.5 degrees of camber, on a 9.5. if you are going that low you'll probably need a 225. No camber and your going to be high 20s to 30s

The rear IDK, i don't have experience with the 10.5. I spaced my 9" out to where a 10.5 +28 would be. it didn't rub but i wasn't really feeling the look with the tire so i'm going to try 5mm higher offset.

[Moffo]

Originally Posted by blumagic

lowest offset in front is going to be around +20 with ~2.5 degrees of camber, on a 9.5. if you are going that low you'll probably need a 225. No camber and your going to be high 20s to 30s

The rear IDK, i don't have experience with the 10.5. I spaced my 9" out to where a 10.5 +28 would be. it didn't rub but i wasn't really feeling the look with the tire so i'm going to try 5mm higher offset.

Do you have any pictures bro?

[blumagic]

Originally Posted by Moffo

Do you have any pictures bro?

Yeah, this is 19x9 et9 in front (about the same poke as 9.5 et15) with -2.5, rear is 19x9 +24 (same poke as 10.5 et28) with ~ -2. 225/40 all around. I tried a 10mm in the rear and it looked off, I think 5mm will be better.

No roll, no pull, no rubbing at all. I’m not really slammed though, but still zero rub on compression.

[Korvo]

Originally Posted by blumagic

[img]

View post on imgur.com

[/img]

Beautiful stance. Well done!