01-24-2019, 09:38 PM | #1 |
New Member
3
Rep 8
Posts |
"No Signal' Corrupt coding data
Help Needed...Head Unit crashed..Yesterday I tried coding with the Bimmer app using a cheat sheet in expert mode and received a ECU corrupt: Cannot be coded..I tried restoring from a backup but no luck...Decided to connect via Esys to see the problem was seems that i haver 2 instances running on the same ECU..How can I restore the corrupt HU_NBT ECU or repair this one...Pics below..Thank you
Last edited by Paul Koury; 01-24-2019 at 09:53 PM.. Reason: Adding Photos |
01-25-2019, 05:09 PM | #4 |
Enlisted Member
11
Rep 43
Posts |
I actually had that happen to me without any doing any coding at all, NBT unit had a fault and had to be replaced, would just come up no signal
|
Appreciate
0
|
01-30-2019, 12:03 PM | #5 |
BimmerPost Supporting Vendor
665
Rep 1,976
Posts
Drives: 2020 G20 320i M Sport
Join Date: Apr 2010
Location: Canada & HK
|
Check the log under C:\Data\ and see what the "More than one condition is active " part fully says. It may point to something.
__________________
CMB Solutions Limited |codemybimmer.ca
Vehicle Diagnostics | CarPlay Solutions | Retrofit & Repair Consulting/Programming steve.ma@cmbsolutionsltd.com | www.codemybimmer.ca Online Store | Remote Coding Package| ID6 Retrofit for almost all F Chassis BMWs |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|