06-12-2020, 09:32 PM | #1 |
Enlisted Member
12
Rep 41
Posts |
Car wont engage in Sport/Sport+
Car wont engage in Sport/Sport+...
Or it will engage awhile and goes back to comfort after 10 seconds... I just got a custom tune from BM3 from a tuner... Cleared fault codes through Carly, no change... Any idea what's wrong? Update: there's a "Chassis. Drive Moderately" message now...
__________________
335i F30 PWG, PS2, XDI-35, ER DP, CSF FMIC, MST AI, BM3, Snow Perf WMI
Last edited by enlimalima; 06-12-2020 at 10:16 PM.. |
06-12-2020, 09:52 PM | #2 |
Captain
212
Rep 816
Posts
Drives: Bmw 335i f30 N55 ( sold)
Join Date: Nov 2017
Location: Venice Florida
|
Bm3 is the problem.. go mhd 😂😂 no honestly idk the answer too this.
__________________
2012 bmw 335i sedan
VRSF catless DP VRSF 5? HD IC Stock intake(had open before and was sick of noise) BMS CP 550i 351m rims with 275/245 set up. No tune as of yet. |
Appreciate
0
|
06-13-2020, 06:07 AM | #3 | |
Private
23
Rep 73
Posts |
Quote:
|
|
Appreciate
0
|
06-13-2020, 04:55 PM | #5 | |
F36 GC
143
Rep 259
Posts |
Quote:
|
|
Appreciate
0
|
06-15-2020, 06:16 AM | #6 | |
Enlisted Member
12
Rep 41
Posts |
Quote:
D016F2 - Check control display, driving dynamics, receiver ICM, transmitter EDC D0193C - predefined damper passive component, receiver ICM, transmitter EDC No idea what this is... I replaced the stock suspension to KW DDC coilover 8 months ago, and everything was fine. When I was tuning I had my car on a hub dyno...dunno if that played part or not...
__________________
335i F30 PWG, PS2, XDI-35, ER DP, CSF FMIC, MST AI, BM3, Snow Perf WMI
|
|
Appreciate
0
|
06-15-2020, 08:14 AM | #7 | |
Private
23
Rep 73
Posts |
Quote:
I'm assuming you have adaptive suspension. If it's been working fine all this time, it might be a loose wire, bad sensor or need to be coded |
|
Appreciate
0
|
11-21-2021, 08:44 PM | #9 |
Private
8
Rep 53
Posts |
I'm glad I found this. I had the same issue (Drivetrain malfunction) after a hard pull. The scan showed the same two codes: D016F2 and D0193C. It turns out it was a 5A fuse that was gone, but I think it was because my meth injection uses that circuit as a power supply.
|
Appreciate
0
|
12-07-2021, 07:02 PM | #11 |
Registered
0
Rep 2
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|