[chowser51]

I tried search and google and couldn’t find anything. My googlefu is weak.

Since no one sits in the rear at all, while trying to figure out how to mount a rifle lock behind the seat (I don’t use the wind deflector so it stays in the garage), I removed the headrests and like not having them.

I don’t like the look of the holes though. Anyone make anything or have access to a 3D printer?

[silvercas]

3D print your own?

[chowser51]

I wish I had a 3D printer. I guess if I make the file I can go to our library and have them print it. I’m going to hit the hardware store sometime today during my shift and see what I can find.

[sinkers]

Originally Posted by chowser51

I wish I had a 3D printer. I guess if I make the file I can go to our library and have them print it. I’m going to hit the hardware store sometime today during my shift and see what I can find.

The best thing I could find was these holes was 4 of these: https://www.ebay.co.uk/itm/232784369039 (25mm x 25mm)

[GatorRob]

Excuse the dumb question but how exactly did you take the headrests off. I’d like to do that but cannot figure out how they come off.

[chowser51]

The holes are still open . I gave up.
Doesn’t bother me anymore. Need to figure out how to use them to mount a rear dash cam.

I put the top down (obviously) and I can’t remember if there was a lever but you have to yank up really hard. It feels like it’s stuck but they will come out.

[BMWinAZ]

Silly putty or chewing gum