10-09-2015, 03:04 PM | #1 |
Private First Class
53
Rep 198
Posts |
Coding Whoops...
So i was playing around with the ASD ecu and i think i may have accidentally coded the green KOMBI cadf item (i had not read the FDL for this item) rather than the ASD one i had been editing.
While this was coding the car "rebooted" and came up with a message saying their was an issue with the instrument cluster and i should go see my local BMW service dept. My trip computer also reset and i have a exclimation at the top right of the display between the dials. So the question is, what did i do? write a load of default values to the KOMBI? If so how would writing the FA (i have a backup of my last change) back install the last settings? Last edited by Tronneh; 10-09-2015 at 03:31 PM.. |
10-09-2015, 05:41 PM | #3 |
Lieutenant Colonel
288
Rep 1,892
Posts |
It sounds like you just VO coded the KOMBI. This just initializes it to the factory default (which sounds like it was already at).
Whenever you VO or FDL code an ECU, the ECU is restarted. On the KOMBI, that resets the trip odometer, the clock, and the outside temperature reading. The warning error usually goes away after you stop the restart the car. The exclamation mark is usually just an indication telling you to reset the time. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|