04-09-2018, 05:38 AM | #111 |
Captain
604
Rep 631
Posts |
|
Appreciate
0
|
08-05-2018, 02:10 PM | #113 |
Second Lieutenant
208
Rep 262
Posts |
Just did this to my M3. Problem solved.
Only issue is that the 15' roll cost $36 and was about 6" too short to do both sides with no waste. Despite this, the creaking is gone. |
Appreciate
1
Speedwell-Industries434.00 |
08-05-2018, 03:16 PM | #115 |
Captain
373
Rep 937
Posts |
Idk man, I rather not get some wax build up on the felt trim that meets with the shadowline trim
__________________
Hi
|
Appreciate
0
|
08-05-2018, 08:08 PM | #116 |
Second Lieutenant
171
Rep 257
Posts |
I didn't feel like going back to the dealer, so I bought a spray can of 6% silicon spray, and just spray a paper towel with the silicon and wipe the trim above the doors from front to back.
The spray is expensive, but one treatment seems to last for weeks and lasts even after a wash. Just watch overspray because this stuff is slippery and hard to remove once it hits something.
__________________
2021 i3s AC Schnitzer BMW CCA #67486 |
Appreciate
0
|
08-05-2018, 08:23 PM | #117 |
Enlisted Member
42
Rep 43
Posts |
I used this so far great!
nextzett 91480615 'Gummi Pflege... https://www.amazon.com/dp/B004B8GTQG?ref=yo_pop_ma_swf |
Appreciate
1
DL335D580.00 |
08-05-2018, 09:30 PM | #118 | |
Second Lieutenant
171
Rep 257
Posts |
Quote:
__________________
2021 i3s AC Schnitzer BMW CCA #67486 |
|
Appreciate
0
|
08-05-2018, 09:31 PM | #119 | ||
Enlisted Member
42
Rep 43
Posts |
Quote:
|
||
Appreciate
0
|
02-20-2019, 09:49 AM | #121 |
Captain
2493
Rep 616
Posts |
I have a '18 M3 and have tried gummi and wax and the creaking always comes back after a month or so and a couple car washes.
Thank God I found this thread! I will tackle this project this weekend. Will not take my car to a dealer for this. They managed to scratch my trunk during the last oil change. Thank you OP for putting together the DIY!!! |
Appreciate
0
|
02-26-2019, 09:26 PM | #122 |
Captain
2493
Rep 616
Posts |
Bought the tape at Amazon for $6 and spent 15 min tops Saturday morning following OP's DIY.
Super happy with the result! Zero creaks and I'm sure they won't be back! |
Appreciate
0
|
02-27-2019, 07:08 AM | #123 |
Second Lieutenant
153
Rep 260
Posts |
Has anyone tried this on the convertible? Because it's a frameless door, and there's a rear quarter window which directly contacts the front door window glass.
|
Appreciate
0
|
02-27-2019, 09:12 AM | #124 |
First Lieutenant
203
Rep 370
Posts |
|
Appreciate
0
|
02-27-2019, 12:07 PM | #125 | |
Captain
2493
Rep 616
Posts |
Quote:
I went with 0.5" width and it's perfect. Good luck! |
|
Appreciate
0
|
03-24-2019, 06:43 PM | #127 |
Lieutenant
161
Rep 446
Posts |
does the bulletin applies to canadian cars? 16' 340i
__________________
=================================
Mod bug will bite you if you buy a BMW ================================= |
Appreciate
0
|
07-22-2019, 09:30 AM | #128 |
Registered
0
Rep 1
Posts |
Does SIB 51 28 10 actually cover the F30. I took my car to the dealer last week, who told me it didn't apply. They just cleaned the seals which fixed the issue for about 4 hours.
Does anyone have a copy of the SIB they could post (or send me)? Thanks |
Appreciate
0
|
08-06-2019, 09:54 AM | #129 |
New Member
0
Rep 26
Posts |
This creaking is comming from 2 parts:
1. The shadow line trim which can be fixed with the teflon tape. 2. The glass rubbing against the seals causing the sound. The only fix i think is changing door glass seals? Or put some material inside, where the glass is moving. I already applied teflon tape and the creaking is less but continue to have creaking from the glass and seal! Please help! |
Appreciate
0
|
08-06-2019, 04:43 PM | #130 | |
Colonel
1996
Rep 2,499
Posts |
Quote:
It literally takes 5 minutes to thoroughly clean all those seals and they will work better if kept clean anyway. I'd rather keep them clean then apply tape to the car. |
|
Appreciate
0
|
07-28-2020, 10:05 PM | #131 |
Private First Class
38
Rep 102
Posts |
Sorry for the bump, but I searched and couldn't find anything solid on this -- did anyone get this to work on the convertible?
I have an 2020 F83 and the creaks and squeaks are worse than the 10 year old Honda I bought in high school. Dealer is claiming "the convertible top is operating as expected". |
Appreciate
0
|
07-01-2021, 08:24 AM | #132 |
Major
446
Rep 1,369
Posts |
If you are out of warranty and didn't plan on spending over $250 for magic tape the following solution might help. Fingers crossed
https://f30.bimmerpost.com/forums/sh...6#post27756776 The short version: 1) Clean all seals, especially between upper seals, with a microfibre towel + water, then clean again with silicone remover. 2) Lube between seals with the KSP 105. You can go insane spreading the KSP 105 all over the place but start by cleaning and lubing between the upper door seals. See how far that takes you then lube additional areas. Good luck.
__________________
340i xDrive (F30), 228i (F22), 320 (F30), 325i (E46)
Last edited by casualDIYer; 07-01-2021 at 11:20 AM.. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|