02-21-2024, 04:37 AM | #1 |
Lieutenant Colonel
595
Rep 1,693
Posts |
HU_NBT wrong bus error when writing SVT for an unrelated change
I'm preparing to permanently remove my TCB. I removed the 6AC and 6AE options and added the HO-Wort "TELD" on the FA and wrote the FA to the VCM.
I read the SVT from the VCM, removed TCB, saved it then opened the file in the VCM section. When I went to write SVT, it gave the error attached. I did not proceed. I then did a "Read (ECU)" and compared the files of the SVT read from the VCM and the "Read (ECU)" (I'll call it "actual") one and found a difference: SVT from VCM: <ecuBusConnectionInfo busType="ETHERNET" busID="15"/> SVT actual: <ecuBusConnectionInfo busType="ETHERNET_63" busID="22"/> Should I: 1) Ignore the error and write the VCM based on the SVT taken from the VCM. 2) Use the SVT data from the "Read (ECU)" to write to the VCM. |
02-21-2024, 07:45 PM | #2 |
Lieutenant Colonel
595
Rep 1,693
Posts |
I ended up going for an option 3 haha.
I edited the file from the VCM and changed the HU_NBT to busType="ETHERNET_63" busID="22". No error. no issues. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|