01-17-2022, 07:09 PM | #1 |
New Member
6
Rep 28
Posts |
Front PDC coding
Hi everyone
I got a problem with coding , I install front pdc retrofit (I have rear from beginning) , all coding was without any error but then I see on screen that there is error with park sensors and I need go to service , it's doesn't work at all , rear and front. I put the wire wrong ? Or I need to update my rem ecu? My car is from 2013 |
01-17-2022, 08:05 PM | #2 | |
Captain
130
Rep 765
Posts |
Quote:
|
|
Appreciate
0
|
01-18-2022, 11:27 AM | #3 |
New Member
6
Rep 28
Posts |
It's possible because I made cable by myself
I put cable from 6-pin socket like this Pin 1 to A174*14B PIN 48 Pin 2 to A174*14B PIN 36 Pin 3 to A174*14B PIN 53 Pin 4 to A174*14B PIN 40 Pin 5 to A174*14B PIN 41 Pin 6 to A174*14B PIN 52 It's that correct? |
Appreciate
0
|
01-18-2022, 05:30 PM | #4 |
Captain
130
Rep 765
Posts |
Not sure sorry I only did rear pdc. Did u remove the code for rear pdc then added the single code for both? Idk if it would let u so that but I would definitely check the wiring and connections and coding. If all else fails u can try flashing. My rear pdc didn’t work until I flashed but since ur rear is already working I’d be surprised if it needs flashing but I can’t say for certain. Check n double check your wiring. Imo
|
Appreciate
0
|
01-22-2022, 12:12 PM | #6 |
Lieutenant
136
Rep 525
Posts |
Do TAL calculation with esys and you will see if you need other REM
__________________
Successfully retrofit on BMW F30 335xi 248,302,3AG,430,5AG,5AS,6NS,8TH and IHKA3
|
Appreciate
0
|
01-26-2022, 08:52 PM | #7 |
Captain
130
Rep 765
Posts |
Are the pins in the rem there? I hope that’s not the case bc I bought a rem with rear n been meaning to do front pdc. Hate to have to get another rem. Pls lmk.
|
Appreciate
0
|
01-27-2022, 07:10 PM | #8 |
New Member
6
Rep 28
Posts |
I check and my rem is fine , when I use ISTA it's shows "short circuit" so I guess I do something wrong with pins , I use 928999 pins
I use 0.35 cable like it's shows on diagram so maybe I suppose to use 0.5 cable ? |
Appreciate
0
|
01-29-2022, 02:27 PM | #9 |
Captain
130
Rep 765
Posts |
I doubt that’s the issue. Make sure the pins are fully in on the rem connector and just verify the wiring n double check all connections.
|
Appreciate
0
|
01-29-2022, 02:29 PM | #10 |
Captain
130
Rep 765
Posts |
U can try to upgrade the istep if u run out of options. The rem I bought came from a car with rear pdc n after installing rear pdc it still don’t work until I flashed it. The istep might be too different from ur car. Worth a shot.
|
Appreciate
0
|
02-02-2022, 12:48 PM | #13 |
Captain
130
Rep 765
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|