12-13-2018, 12:17 AM | #1 |
Second Lieutenant
103
Rep 285
Posts
Drives: 2014 428i XDrive
Join Date: Feb 2018
Location: North East
|
BM3 Emissions
Do I have to flash back to stock for emissions testing?
The CEL off function/feature is NOT enabled. I have a Catted ER DP that throws no CEL stock / bm3. Thanks |
12-13-2018, 08:15 AM | #2 |
Brigadier General
2000
Rep 3,680
Posts |
Depends on the state. Some states just scan for emissions codes, some actually measure the exhaust gases on the spot.
__________________
Instagram: rjd_f30 | Current: EBII 2013 335i 6MT RWD & Sprint Blue 2008 Audi RS4 | Retired: 2013 328i, 2000 XTerra, 2022 Civic Si |
|
Appreciate
0
|
12-13-2018, 08:59 AM | #3 |
Second Lieutenant
103
Rep 285
Posts
Drives: 2014 428i XDrive
Join Date: Feb 2018
Location: North East
|
|
Appreciate
0
|
12-13-2018, 09:05 AM | #4 |
Brigadier General
2000
Rep 3,680
Posts |
Should be fine if it's just OBDII.
__________________
Instagram: rjd_f30 | Current: EBII 2013 335i 6MT RWD & Sprint Blue 2008 Audi RS4 | Retired: 2013 328i, 2000 XTerra, 2022 Civic Si |
|
Appreciate
0
|
12-13-2018, 06:37 PM | #5 |
Second Lieutenant
103
Rep 285
Posts
Drives: 2014 428i XDrive
Join Date: Feb 2018
Location: North East
|
Hey... so this is what I got on my OBD II reader
Do you know what the three X's mean? Edit:^ Available: X means the sensor itself cannot be read / does not exist in the car. Available: X - COmplete: X - good Available: V - Complete: X - not ready / not good. Last edited by lonecitizenfour; 12-13-2018 at 06:54 PM.. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|