[drapi13]

Hi guys i tried to code 5AG but i have problem with CAF files:

So after installation i updated the VO, i coded all modules and than i tried to initialize flex-ray... but every time the initialization was successful when i should get error since the HC2 module wasn't coded yet. So if the flexray initialization was successful i wasn't able to see HC2 (or SWW in ISTA+). So i opened port 4 flex ray with tool32 and since then i was able to see HC2 BUT!!! :

In this step i should create a Cafd file for HC2.
I have two HC2 modules one new and one used.
My i-step is F020-15-07-502
On the used HC2 e-sys shows me files form y2012
and on the new one i get from:
F20-16-03-500 till F20-17-03-505
So non is compatible with the car i inserted F20-16-03-500 but in ISTA+ i get :



Ofc coding in ISTA does nothing and if i reinitialize flexray with ISAT+ it closes port 4 and SWW disappears.

Can some one help me with some advice ?

[drapi13]

Enyone ??

[deneyer]

I have the same problem did complete retrofit, initalised flex ray didn't get error but succes and no HC2 module to find. So cant installed CAFD file

Don't have tool32 so can't open flexray.

Anybody any ideas what the problem is?

[markqu]

Originally Posted by deneyer

I have the same problem did a complete retrofit, initialised flex-ray didn't get error but succes and no HC2 module to find. So cant installed CAFD file

Don't have tool32 so can't open flexray.

Anybody any ideas what the problem is?

I have the same problem with you, do you hc2 module found, thx

[deneyer]

Originally Posted by markqu

I have the same problem with you, do you hc2 module found, thx

Probably means you bought the wrong master/slave module

[markqu]

Originally Posted by deneyer

Probably means you bought the wrong master/slave module

I already open the port by tool32, hc2 module was found and sww working now
but had an error code in Rheingold, that remind initialization FlexRay.
but the FlexRay port will be closed when I initialization FlexRay. what can I do next?
Thx

[nyuly]

Originally Posted by markqu

I already open the port by tool32, hc2 module was found and sww working now
but had an error code in Rheingold, that remind initialization FlexRay.
but the FlexRay port will be closed when I initialization FlexRay. what can I do next?
Thx

HI , i have the same problem . Did you solved it ?thanks .

[nyuly]

Problem solved .

[PisuM]

Originally Posted by nyuly

Problem solved .

Hi,
How did you resolved the problem? In my case , tried with tool32 0x03;0x01 and still with EIN status.is there something i am missing? Could some give an advice?

[Siki78]

reset flexray after opening port

steuern_flexray_pfad=>0x03;0x01=>F5
steuern_reset_learn_flexray=>F5

[iansolway]

uy