08-08-2023, 05:55 AM | #1 |
New Member
19
Rep 28
Posts |
Unit needs new coding, how to?
Hello,
By a friend of me his NBT Unit and 8.8 screen etc has been stolen. So now he has bought a set for the smaller screen and unit. Only now when he connect to this unit with Bimmercode he gets a popup with the warning "coding data invalid". Because he doesn't have a laptop I offered I could help him, but can someone explain what needs to be done? I have added a picture of the unit he has, now I guess this is a HU_ENTRY unit? I also uploaded a short video of what he sees now with this unit. https://www.youtube.com/shorts/slJHKOJZPco Last edited by fabje; 08-09-2023 at 02:12 AM.. |
08-08-2023, 12:43 PM | #2 |
Banned
578
Rep 2,047
Posts |
This is HU_ENTRYNAV2.
You will have to write the vin and code it. You would also need to remove component protection. Write VIN. E-Sys => Expert Mode => FSC Extended=> In Diagnostic Address enter 0x63 and click Identify => WriteDataByIdentifierVIN = Enter xxxxxCARxVINxxxxx => Press “Start” button and check Log window for “ok” result. Coding Connect => Read FA (VO) => Activate FA (VO) => Read SVT (ECU)=> Left-Click on NBT => Click on "Detect CAF for SWE" => Select the CAFD from latest I-Level shown (bottom) => Select OK => Right-Click on NBT (the ECU itself not the underlying CAFD) => Select CODE. |
Appreciate
0
|
08-09-2023, 02:57 AM | #4 |
New Member
19
Rep 28
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|