02-21-2018, 01:35 PM | #1 |
Lieutenant
235
Rep 584
Posts |
Drivers window
Hi, guys, is the drivers window supposed to close fully after one touch of the switch? Mine doesn’t, have tried opening and closing it a couple of times but doesn’t make any difference. I’ve again but doesn’t seem to mention my issue.
Mick |
02-21-2018, 02:01 PM | #2 |
Lieutenant
205
Rep 404
Posts |
without actually getting in the car and checking from memory a full press closes it all the way, IIRC it's a two stage switch or a slightly longer press to get it all the way up.
|
Appreciate
0
|
02-21-2018, 04:36 PM | #4 |
Private First Class
86
Rep 149
Posts |
|
Appreciate
0
|
02-21-2018, 04:45 PM | #5 |
Private First Class
48
Rep 131
Posts |
After some events (such as disconnected battery) you have to re-initialise the soft touch.
It doesn't read too well, but the below might help: An initialization must be performed: ? In the event of malfunctions, e.g. no one-touch control function, no opening or if available no comfort function is possible ? After the power window drive has been replaced ? After work is carried out on the power window mechanism ? If necessary, after an open circuit, e.g. disconnection of the battery or disconnection of the power supply to the door ? After the door window glass has been removed and installed or replaced ? After adjustment work on the door window glass ? After adjustment work on the convertible top ? After replacement of seals Initialization is performed on the power window switch of the relevant door. Requirements for correct initialization: ? Terminal "R" activated ? Doors and windows closed ? Sufficient battery voltage; connect charger if necessary Initialization comprises: ? Erasure of initialization ? Reinitialization Erasure of initialization: ? Open door window glass fully ? Actuate power window switch in "Open" position (second switch position) and hold down for between 15 and 20 seconds This clears initialization of the power window. Anti-trapping protection and one-touch control (toll) function are inactive. Check whether one-touch control (toll) function is inactive, otherwise repeat procedure. Reinitialization: ? Close door window completely ? After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in "Close" position (second switch position) ? Open door window glass fully ? After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in "Open" position (second switch position) ? Close door window completely ? After upper end position is reached, interrupt actuation of power window switch and then hold switch again for approx. 1 second in "Close" position (second switch position) This completes initialization. Note: Carry out function check (one-touch control function, anti-trapping protection and, if necessary, comfort function). Note: The power window can also be initialized in the BMW diagnosis system by means of a diagnosis job. |
Appreciate
0
|
Post Reply |
Bookmarks |
|
|