[STCCEdition]

Hi guys!

So looking to change out the footrest to a Stainless M footrest...
But i cant seem to remove the old footrest somehow? Has anyone done this?

Happy new year to all you out there

[John in VA]

I'm sure the TIS has instructions, but I couldn't find it with a cursory look. Check: https://www.newtis.info/tisv2/a/en/f...ism+trim+panel

https://www.newtis.info/tisv2/a/en/f...1-f22/IdOLQQNw

Good luck!

[JDTX]

Originally Posted by John in VA

I'm sure the TIS has instructions, but I couldn't find it with a cursory look. Check: https://www.newtis.info/tisv2/a/en/f...ism+trim+panel

https://www.newtis.info/tisv2/a/en/f...1-f22/IdOLQQNw

Good luck!

I believe you are referencing the plastic trim below the steering column, not the "dead" pedal or footrest. That is held from behind the carpet as I understand. I simply used a Chinese copy that glues (with 3M tape) over the black footrest.

[7iM3less]

The black plastic footrest is glued down and clipped from the factory. It's pretty permanent.

When I replaced mine to an m sport footrest I had to yank the original off and epoxy the new one on.

[iliamerk]

Originally Posted by KC328_F30

The black plastic footrest is glued down and clipped from the factory. It's pretty permanent.

When I replaced mine to an m sport footrest I had to yank the original off and epoxy the new one on.

Was it not flush to just put the m sport footrest over top? Or just preferred to do a full replacement?

[7iM3less]

Originally Posted by iliamerk

Was it not flush to just put the m sport footrest over top? Or just preferred to do a full replacement?

The m sport footrest comes as a complete part and can't be stuck over top of the old one. They're different designs as well.

[JDTX]

Originally Posted by iliamerk

Was it not flush to just put the m sport footrest over top? Or just preferred to do a full replacement?

Only the Chinese replicas can be put on top of the existing footrest. However it only adds about 5mm height so for me it was a good compromise.

[iliamerk]

Originally Posted by KC328_F30

The m sport footrest comes as a complete part and can't be stuck over top of the old one. They're different designs as well.

Originally Posted by JDTX

Only the Chinese replicas can be put on top of the existing footrest. However it only adds about 5mm height so for me it was a good compromise.

Gotcha. I had ordered a set of reps off amazon and my understanding was that they're stick on. I guess KC328's are OEM.

[7iM3less]

Originally Posted by iliamerk

Gotcha. I had ordered a set of reps off amazon and my understanding was that they're stick on. I guess KC328's are OEM.

I'm referring to the footrest, are you talking about pedals?

Rep pedals are slip on.

[JDTX]

Originally Posted by KC328_F30

I'm referring to the footrest, are you talking about pedals?

Rep pedals are slip on.

Yes, I was referring to the footrest/dead pedal. The OEM is a complete replacement and rather difficult. The Chinese copies are glued on top. See this:

[aps]

Originally Posted by KC328_F30

The black plastic footrest is glued down and clipped from the factory. It's pretty permanent.

When I replaced mine to an m sport footrest I had to yank the original off and epoxy the new one on.

What kind of epoxy did you use? I yanked mine out and ripped the plastic rivets out of the back, but then realized my new pedal haus dead pedal needed to stick on the OEM dead pedal