04-21-2020, 05:05 PM | #45 |
Captain
552
Rep 684
Posts
Drives: Your mom crazy
Join Date: Feb 2015
Location: Sioux Falls SD
iTrader: (0)
Garage List 2020 BMW X3M CURRENT [0.00]
2016 BMW 340i BEAST [0.00] 2011 BMW 335i RIP [0.00] 2003 BMW 330i SOLD [0.00] |
Yeah this is not that hard.
My approach was always to run the tank down to about 2 gallons left and then always put in 13 gallons of the correct % mix. You don't need to worry about calculating what % of ethanol is in the tank, just make sure whatever quantity you're adding is slightly less than available capacity and it's the right percentage. If this is too complicated for you, you should rethink tackling these kinds of mods. Sorry not sorry...
__________________
2020 X3M
MG Flasher; Wedge Performance E50 tune MSS Urban; Rohana RFX11 |
Appreciate
1
SC_B5X403.00 |
04-24-2020, 11:09 AM | #47 | |
Second Lieutenant
315
Rep 232
Posts |
Quote:
You can check my V2 log all the way at the top I'm on 93 octane. If I read correctly I peak around 19 ish psi
__________________
YT: Conrad B
IG: conradb_93 |
|
Appreciate
0
|
04-25-2020, 08:30 AM | #48 | |
Cheapskate
4450
Rep 4,993
Posts |
Quote:
|
|
Appreciate
0
|
04-27-2020, 10:40 AM | #49 | |
Enlisted Member
10
Rep 32
Posts |
Quote:
Slightly off topic but..I have a 440i and running a simple jb+ boost controller and that's it, no other mods...I've ran sunoco 260GT race fuel 100 octane unleaded straight before..With this in the tank and jb+ set to default (4 psi over stock) I have seen as high as 18.9psi via odb2 port reading..I know that reading isn't accurate due to jb+ but Its never read that high before with just 93 octane in the tank... Plus the actual boost is even higher anyway right? In your opinion is this a safe boost range on 100 octane? |
|
Appreciate
0
|
04-29-2020, 06:10 PM | #50 |
Brigadier General
1161
Rep 3,189
Posts |
Well I was one of the lucky ones to get a used supra hpfp, so just need the bms adapter to come in and for this updated tune to drop. Excited to get some logs.
|
Appreciate
0
|
04-29-2020, 07:01 PM | #51 |
Private First Class
58
Rep 198
Posts |
|
Appreciate
0
|
04-29-2020, 07:08 PM | #52 |
Brigadier General
1161
Rep 3,189
Posts |
|
Appreciate
0
|
04-29-2020, 07:14 PM | #53 |
Lieutenant
316
Rep 420
Posts |
Todays update brings many new things to the B58 GEN1 platform.
We added our new ST2+HPFP maps, these maps require a upgraded fuel pump, you can either use the stock B58TU1 pump (Supra, Z4M40J, M340i...) - BMW OEM part number 13518631642 or a Dorch / XDIHPFP. The power gain across the complete power band is pretty impressive and the performance numbers are simply incredible. At the moment we offer 95/102 and E30 variants, 91/95 and 93/98 variants are in beta testing. The В58 is a high compression engine, low quality fuel and high boost can cause issues and we always want to offer 100% safe and reliable maps, the ST2 maps already nearly maxes out those fuels, thats why we need some more time on testing the low quality fuels at high boost ST2+HPFP maps and then decide if results are aood enouah for a maps already nearly maxes out those fuels, thats why we need some more time on testing the low quality fuels at high boost ST2+HPFP maps and then decide if results are good enough for a release. We also updated all our B58 GEN1 maps to V3.1 with big improvements to the low end and overall drivability. The top speed limiter is now fully deactivated on all B58 cars (294KPH before) and we applied some changes to the cooling options. Performance results on B58 GEN1 ST2+HPFP ЕЗО тар from one of our beta testers (M140I XDrive SAT): 1/4 Mile 10.72s @ 128MPH (B58 GEN1 stock turbo world record!) 100-200 KPH in 6.9s 0-100 KPHin3.Gs 0-60 MPH in 2.87s Dynojet:522HP/743NM
__________________
M140IX. Turbo Pure 800 Cast.
|
Appreciate
1
OzBMR574.50 |
04-30-2020, 12:47 AM | #54 |
Lieutenant
316
Rep 420
Posts |
I updated the map Mhd 2+. First impressions are: The engine has a powerful mid 3500/5500 rpm with a boost of 1.45 kg at the peak on a 30/40% throttle. This mode is very suitable for the track, where there are many twisty turns. On the move, an increase of 100/200 km / h was 0.3 s. The remaining observations and measurements will be done later.
__________________
M140IX. Turbo Pure 800 Cast.
|
Appreciate
1
OzBMR574.50 |
04-30-2020, 02:49 AM | #55 | |
Captain
575
Rep 585
Posts |
Quote:
Good improvement.
__________________
Tesla Model 3 Performance 0 - 60mph 3.1s
M140i LCI Mineral Grey Dorch Stage 2 HPFP, CG Precision DS-1, XHP, MHD Stage 2 HPFP E30 @ E42 100 - 200 6.96s Quarter mile 10.93@127mph |
|
Appreciate
0
|
04-30-2020, 07:44 AM | #57 | |
Captain
575
Rep 585
Posts |
Quote:
MHD Stage 2+ is 95 octane (102 RON) or E30 only This one tested is Stage 2+ 95 octane and you use 98RON with MMA to boost octane to 95 (102RON)? 7,9s 100-200 would be about 430WHP - 440 WHP for M140iX, so maybe 10 WHP up from V3.0
__________________
Tesla Model 3 Performance 0 - 60mph 3.1s
M140i LCI Mineral Grey Dorch Stage 2 HPFP, CG Precision DS-1, XHP, MHD Stage 2 HPFP E30 @ E42 100 - 200 6.96s Quarter mile 10.93@127mph |
|
Appreciate
0
|
04-30-2020, 08:09 AM | #58 |
Lieutenant
316
Rep 420
Posts |
We do not have an E30. Only 98 Ron. You have to add MMA so that it becomes 102RON. This version 3.1 gave the motor a very urgent middle, just to fit in these revolutions when passing the suburban highway at speeds of 80 / 160km / h. Tomorrow I’ll try to turn on the methanol JB4 map 6. I’ll measure it and write what happened.
__________________
M140IX. Turbo Pure 800 Cast.
|
Appreciate
0
|
05-02-2020, 10:50 AM | #59 |
Lieutenant
316
Rep 420
Posts |
Finally I did all the measurements. So in order. JB4 is completely off, the connectors are removed from the sensors on the engine. There is no methanol. 1. MHD stage 2 98 Ron: 100/200 - 8,2s. 1/4 miles - 11.56. 2 MHD stage 2+ HPFP: 100/200 - 7,9s. 1/4 miles - 11.38. 3. MHD stage 2 + HPFP E30 (begged from drifters) is the best option for racing and active driving! 100/200 - 7,6s. 1/4 miles - 11.19s. All measurements were on the same stretch of road, with the same weather and air temperature (+12/14 C). Conclusion: With this setting, JB4 with methanol is no longer needed. The car and so it goes perfectly in the entire speed range. Of course, individual tuning can still improve the result, but I plan to install VTC GS and even then I will order a Map for my car.
__________________
M140IX. Turbo Pure 800 Cast.
|
05-02-2020, 12:47 PM | #60 |
Major
809
Rep 1,369
Posts |
^^
That's why I sold my JB4. Great product and company and I commend Terry for all he's done for our community over the past 13 years, but we have evolved.
__________________
2017 M240i/ ZF8 Pure Drivetrain Solutions Stage 1 & torque converter/xHP/ DAW Ultra Flow/ DS2/ Nostrum injectors/ E40 Doug Newton tuned/ ER DP/ Remus axle back/ BMS intake/ FTP CP/ M Perf LSD
|
Appreciate
0
|
05-02-2020, 05:12 PM | #61 | |
Private First Class
29
Rep 135
Posts |
B58
Quote:
|
|
Appreciate
0
|
05-02-2020, 05:25 PM | #62 | |
Captain
575
Rep 585
Posts |
Quote:
The Stage 2+ HPFP at 7,6 is far away from the 6,9 the beta tester got. Any thoughts? Can you please post MHD data log of the Stage 2+ E30 at Datazapme in data log thread?
__________________
Tesla Model 3 Performance 0 - 60mph 3.1s
M140i LCI Mineral Grey Dorch Stage 2 HPFP, CG Precision DS-1, XHP, MHD Stage 2 HPFP E30 @ E42 100 - 200 6.96s Quarter mile 10.93@127mph |
|
Appreciate
0
|
05-02-2020, 05:36 PM | #63 |
Lieutenant
316
Rep 420
Posts |
I think 6.9s is hardly achievable without the E50 and individual settings. A mass product from any adjuster is made with a margin of fuel and reliability. I am satisfied with 7.6s)) especially since it is almost free. I wrote logs. I’ll show you how to deal with this magazine site.
__________________
M140IX. Turbo Pure 800 Cast.
|
Appreciate
1
OzBMR574.50 |
05-02-2020, 05:38 PM | #64 |
Lieutenant
316
Rep 420
Posts |
Переведите с русского эту ссылку
https://oduvanchik-him.ru/prisadki-d...-n-metilanilin
__________________
M140IX. Turbo Pure 800 Cast.
|
Appreciate
0
|
05-02-2020, 05:59 PM | #65 |
Lieutenant
316
Rep 420
Posts |
Here is the link to view the magazine.
https://datazap.me/sites/default/fil...oct_102ron.csv
__________________
M140IX. Turbo Pure 800 Cast.
|
Appreciate
0
|
05-02-2020, 06:53 PM | #66 |
New Member
12
Rep 25
Posts |
correct me if I'm wrong. But your log says MHD v1.47. The stage2+HPFP maps were released with v1.48 so is this actually a stage 2+ map or just the older stage 2 102ron map?
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|