09-06-2022, 01:33 PM | #1 |
Private First Class
6
Rep 107
Posts |
Fault code after swirl flap delete
After removing my swirl flaps i get the below fault code and my car goes into limp mode on every start up. If i delete the code after firing up the engine the car runs fine until i turn it off. Any ideas how to fix this issue?
|
09-06-2022, 02:50 PM | #2 |
Major General
6422
Rep 8,501
Posts |
Why did you remove them ? Which components ? Just the flaps, or the flaps + shaft, or perhaps the actuator as well ?
Unlike the previous engine generations they are no longer regarded as a significant risk. The ECU will throw an error code when it is not able to validate that the swirl flap actuation signal has resulted in a mechanical action. I expect you'll need to have the flaps coded-out, but that will typically mean a visit to a specialist tuner.
__________________
Current : F31 330sD, remapped, Ohlins Road & Track, Millway camber plates, Quaife LSD, Stoptech brakes + Pagid RSL1 pads all round, Weichers front strut brace, Eibach front & rear anti-roll bars, Michelin MP4S.
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|