[kubehz]

Hi everyone I own a 2012 328i and getting the following codes under central gateway module. Have tried to look them up on the fault codes site but there isn’t much information. I’ve not really noticed any physical issue but has anyone had these codes before?

1006FF
FlexRay Logger error memory entry
1011FF
Logger error memory entry for other
ZGW components
101008
Non-resolvable ambiguous routing - SG not in the SVT target table
100104
HW Weckgrund ZGW
100001
VcmResultSvtCheck - identity check:
Differences between the SVT actual and SVT target have been recognized.
100203
DM software error info warning
100204
Message monitoring: no system context signal

[TurboWeasel]

Was that a Bimmerlink code in "Info memory"

If so, ignore it. You can sometimes get FlexRay codes when scanning with the engine off. ISTA does it as well sometimes. You only need to concern yourself with faults in "Permanent errors"

FlexRay is the optical bus and can be fickle with battery voltages and response times when communicating with other modules.

[kubehz]

Yes that’s exactly what it was. Thank you