04-21-2024, 12:42 PM | #1 |
Private
20
Rep 77
Posts |
please help with pdc sensors
hey everyone i’m making this post mostly for reassurance, i drive a 15’ 428xi im doing msport bumper conversion, i showed photos of my current base rear bumper pdc and the aftermarket rear bumper. it had me put these inserts in. i believe the inner part is 18mm like my current bumper is but the hole was obviously larger before i put the inserts in. i just wanted to make sure i bought the correct bumper and that my current pdc sensors will fit correctly in the aftermarket one i bought online. do i have any worries?
|
04-22-2024, 08:35 AM | #2 |
Captain
1411
Rep 958
Posts |
FWIW, the rear PDCs on my M Sport rear bumper have inserts like that. I think you’ll be fine…
|
Appreciate
1
f32christian19.50 |
04-22-2024, 08:37 AM | #3 |
Lieutenant
335
Rep 548
Posts |
It is correct to have hole spacers for outside PDC sensors in 4 series M Sport rear bumper cover. As long as you put them in correct side - left or right with correct orientation pointing up or down. I believe spacer could have the UP orientation marked or have a shadow marked on inside surface of the bumper cover.
__________________
2003 E39 530i 5-Speed w/ M Spec, Saphire/Black, M54B30, Active Autowerke Performance Tune
2010 Lancer GTS 5-Speed, Black Pearl/Black, 4B12 2015 F30 335i XDrive w/ M Sport Pack, Alpine White/Black, N55B30M0 2017 F34 340i XDrive w/ M Sport Pack, Azure II /Black, B58B30M0, Dinan Stage 1 |
Appreciate
1
f32christian19.50 |
Post Reply |
Bookmarks |
|
|