[Beygan]

BIMMERPOST / Classifieds

Asking Price:

USD 180.00

Or Best Offer

Shipping Costs Included

Item Interest

For sale is a lightly used Pioneer amp.

Here are the ratings:

Max 1200W
RMS 4Ω - 100W x4
RMS 2Ω - 150W x4
Class FD - 'High Efficiency'

So, this amplifier's a low-budget but quality amplifier, from my personal experience. I had it in my car for about 6 months before it got totaled, which then I went and bought something with the factory Harman Kardon.

Because of this change, I have this amp left from my previous setup, and would like to pass it on to somebody else who desires a decent audio setup.

Best offer, shipping is included. If you could do with my asking, I would humbly appreciate it; this thing is like new! Please see photos for clarification. Thanks!

[Briland33]

Could this amp power a subwoofer on a single channel

[jv92red]

This amp can be bridged to 2 channels for 300W x 2 @ 4ohm.

For just one sub it's not recommended to wire it with 2 channels (assuming it's a dual voice coil sub). While it's possible, I would imagine it could be an issue with channel gain matching issues.

Ideally, for 1 sub (single or dual voice coil) you run a 2 channel amp that you can bridge to mono for the 1 channel needed or run a mono amp)

For a 4 channel amp bridged you can run 2 subs. Two 4ohm SINGLE voice coil subs, or two 2ohm DUAL voice coil subs wired in series or two 8ohm DUAL voice coil subs wired parallel depending on wiring, see below:

[Beygan]

Originally Posted by jv92red

This amp can be bridged to 2 channels for 300W x 2 @ 4ohm.

For just one sub it's not recommended to wire it with 2 channels (assuming it's a dual voice coil sub). While it's possible, I would imagine it could be an issue with channel gain matching issues.

Ideally, for 1 sub (single or dual voice coil) you run a 2 channel amp that you can bridge to mono for the 1 channel needed or run a mono amp)

For a 4 channel amp bridged you can run 2 subs. Two 4ohm SINGLE voice coil subs, or two 2ohm DUAL voice coil subs wired in series or two 8ohm DUAL voice coil subs wired parallel depending on wiring, see below:

...

This is correct! It can be done.