10-03-2017, 07:22 AM | #8 |
Colonel
594
Rep 2,302
Posts |
Delete the 520 from the VO.
Save the VO. Then go to Expert Mode -> Coding. Load the saved VO, activate it. Read VCM or Read Ecu. On the left side mark the FEM. On the right side push the button "Code". Then all codings will be set to standard in relation to your VO( without 520). |
Appreciate
0
|
10-03-2017, 11:32 AM | #9 | |
Private
17
Rep 76
Posts |
Quote:
|
|
Appreciate
0
|
10-04-2018, 03:01 PM | #13 |
New Member
0
Rep 5
Posts |
Hello, First of all thank you for opportunity to be part of this great forum. I was reading this post looking for some insight on this permanent coding delete of the front fog lamps. I have successfully deleted the 520 from VO Coding and also made the necessary changes to the FEM as well. (I THINK) The error for the fog lights is gone but if I push the fog light button on my dash then I get the error again. How can I make the physical button useless if possible? Any help would be greatly appreciated.
|
Appreciate
0
|
10-09-2018, 12:11 PM | #14 | |
Colonel
1066
Rep 2,166
Posts |
Quote:
|
|
Appreciate
0
|
10-09-2018, 02:23 PM | #15 |
Captain
238
Rep 878
Posts |
|
Appreciate
0
|
Post Reply |
Bookmarks |
|
|